• Home
Contact Us

Home / Solutions / Burners & Furnaces / GreenEdge

GreenEdge · Burners and furnaces · Any fuel

CHFA for industrial burners and furnaces, on any hydrocarbon fuel.

Gas, oil, coal or biomass. GreenEdge brings Controlled Hydrogen Fuel Assist to the burners and furnaces you already run, and helps them save fuel — for all industries, not only food processing.

This is not stored hydrogen. The gas is made from water, on demand, in controlled volumes, and used immediately.

Made on demand. Never stored.
Any hydrocarbon fuel
Made in India
GreenEdge industrial system

Up to 12%*

fuel saving

Lower smoke and PM

at the chimney

Lower CO₂

in line with fuel saved

* Savings vary by engine, asset and operating conditions.

Your burners and furnaces are not going anywhere

The boilers, kilns and furnaces that run your process will not be replaced any time soon. The question is what they cost you while they run.

Fuel that leaves as heat, not output

Part of the fuel you fire never fully burns, and the extra air used to keep the flame stable carries heat straight up the stack.

Smoke at the chimney

Incomplete combustion shows up as smoke and particulate matter — the part of your process that everyone outside the plant can see.

Carbon you cannot account for

Every unit of fuel burned is CO₂ on your books. Without measured data, there is nothing to put in an ESG or BRSR report.

Made on demand. Never stored.

We do not replace your burners and furnaces. We make them burn better.

CHFA — Controlled Hydrogen Fuel Assist Technology · Developed & patented by SGT HydroEdge

1

Made from water, on demand

GreenEdge makes its gas from water at your site, as it is needed. Nothing is stored — no cylinders, no pressure vessels.

2

Dosed into the flame you already have

A controlled dose acts as a combustion booster for your existing fuel. The burners and furnaces stay as they are, and so does the fuel.

3

A steadier flame, less excess air

A steadier flame needs less excess air, so less heat is lost up the stack.

4

Measured, not assumed

GreenVision records fuel saved and CO₂ avoided, so the result is a number you can report.

Control is the technology. Too little hydrogen does nothing, too much does harm. The dose follows the load.

GreenEdge unit and digital rectifier installed beside an industrial furnace

Up to 12% fuel saving*

A steadier flame needs less excess air, so less heat is lost up the stack.

Cleaner at the chimney

Lower smoke and PM at the chimney, and lower CO₂ in line with lower fuel consumption.

* Savings vary by engine, asset and operating conditions.

Works with the fuel you already fire

GreenEdge works on any hydrocarbon fuel. There is no fuel switching, and no change to the burners and furnaces, or to the fuel.

Gas

Oil

Coal

Biomass

One model

GreenEdge GE12

A single module, sized up by clustering — so a small hot-water generator and a large furnace are served by the same building block.

12 kW · 3,300 LPH of HHO per module

One model, one building block.

Cluster arrays

Modules cluster in arrays to 10,000, 20,000 LPH and beyond — for redundancy, safety and efficiency.

Power supply and controls

Digital IGBT rectifier integrated with SGT's PLC and controls — designed in-house and built in India to our specifications.

1

Site assessment

We look at your burners and furnaces, the fuel you fire, capacity and operating load.

2

Sizing

We size the GE12 array to your combustion load.

3

Installation and commissioning

The system is fitted alongside your existing equipment and commissioned with your team.

4

Measurement

Fuel saved and CO₂ avoided are tracked through GreenVision.

Attractive ROI, depending on running hours and operating load.

Selected for the CII Ascent Grant 2026

Measured at working plants

Field-validated at customer sites under the CII Ascent Grant 2026.

Field trial

3.6%*

fuel saving

PNG furnace

Field trial

6.6%*

fuel saving

Diesel-fired hot-water generator

* Savings vary by engine, asset and operating conditions.

Confederation of Indian Industry (CII) logo

Selected for the CII Ascent Grant 2026. GreenEdge is field-validated at customer sites under the grant.

GreenEdge unit and digital rectifier installed beside an industrial furnace
GreenEdge unit and digital rectifier beside an industrial furnace
SGT HydroEdge engineers assembling a GreenEdge module
GreenEdge module in assembly
  • Patented technology

    Patent No. 582824, “An Apparatus for Hydrogen Generation and a Method Thereof”

  • ISO 9001:2015 certified

    Quality management system

  • Selected for the CII Ascent Grant 2026

    GreenX and GreenEdge field-validated at customer sites

  • Winner — RAK Innovation Challenge

  • Winner — LEAP Energy Award

  • Peer-reviewed research

    Two papers published with ARAI in ARAI's journal

  • Tested for over three years on real engines

    Validated across multiple customer sites — fleets, DG sets, boilers, furnaces

  • Made in India, end to end

Where GreenEdge works

Any industry that runs burners and furnaces, on any hydrocarbon fuel.

Boilers

Hot-water generators

Furnaces

Kilns

Smelters

Save fuel. Cut carbon. Prove it with data.

Tell us what you fire, in what, and for how many hours. We will size a GreenEdge system for your burners and furnaces.